Adaptec 2100S - SCSI RAID Controller Podręcznik Użytkownika Pobierz pdf (Strona 39)

2-28

Storage Manager on ROM

5 If you are creating a RAID 1 array, the RAID 1 Build Option

window appears, as shown in Figure 2-17. RAID 1 arrays are

built by copying the existing data from one device to the other.

Select the direction for the copy, then select Ok.

Figure 2-17. RAID 1 Build Option Window

6 Select File > Set System Config to start the build process. The

build process begins for the array you created. If you created

multiple arrays, they are built serially in the order they were

defined. Alternatively, you can exit SMOR. Upon exiting, you

are prompted to save the configuration changes. If you save,

the build process begins for any arrays you defined.

For large redundant arrays, the build process can take several hours

to complete. You can exit SMOR and perform other activities on the

system while the build continues. An array being built can be

accessed during the build process.

If you exit SMOR and you want to monitor the progress of the build

operation, you can use the Storage Manager Array Group

Information window. See Array Groups on page 3-12 for additional

information.

Creating a Multilevel RAID

Creating a multilevel RAID (RAID 0/1 or 0/5) is similar to creating

a normal RAID 1 or RAID 5 array group. To create a RAID 0/1 or

RAID 0/5 multilevel RAID, follow these steps:

1 Create and build your array groups as described in Creating an

Array on page 2-26. Do not initiate the build process on any

arrays that you intend to use in a multilevel RAID.

2 After you have created your initial array groups, select

RAID > Create again.

RAID 1 BuildOption:

( ) Copyfrom(1,2,0,0) to (1,0,12,0)

( ) Copyfrom(1,0,12,0) to (1,2,0,0)

Cancel

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 134 135

Brak uwag

Adaptec 2100S - SCSI RAID Controller Podręcznik Użytkownika Strona 39