Adaptec 2200S - SCSI RAID Controller Przewodnik Instalacji Pobierz pdf (Strona 50)

3-19

Installing the Driver

To run the installpkg utility, type installpkg -d disk/.

SCO UNIX reads the disk and prompts you to enter the package

name to be installed.

Type aacraid_tar.z and press Return.

After the package is installed, rebuild the kernel.

Restart the system.

Install the new kernel.

Add devices to the controller.

UnixWare 7 and OpenUNIX 8

Both UnixWare 7 and OpenUNIX 8 use the same procedures for

adding the driver to the system, whether an initial installation or

just adding to an existing system. The driver disk you create will be

specific to one operating system or the other. Once the driver disk

is created, there is no difference in the installation.

Installing the Driver on a New System

In this scenario, you are installing the controller and driver for a

system on which either OpenUNIX 8 or UNIXWare 7 is being

installed as the operating system. The operating system will be

installed on an Adaptec RAID controller-based RAID.

To install the driver:

Install and configure your Adaptec controller and hard disk

drives according to the instructions in Chapter 2.

Create the driver disk as shown at the beginning of this chapter.

Early in the operating system installation, you will be shown a

window labeled Choose One, insert the driver disk, select the

Install HBA diskette entry, then press F10. The driver will load

from the driver disk and return to the HBA screen. Select

Proceed with Installation and press F10.

Complete the installation as appropriate.

When the installation completes, remove the driver disk and

reboot the system.

The boot driver installation process is complete.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 66 67

Brak uwag

Adaptec 2200S - SCSI RAID Controller Przewodnik Instalacji Strona 50