Adaptec 2200S - SCSI RAID Controller Przewodnik Instalacji Pobierz pdf (Strona 48)

3-17

Installing the Driver

For example, the command line to load the driver from the

c:\nwserver directory, with the verbose= option on is:

load c:\nwserver\aacraid.ham slot=2 verbose=y

Command line options are not case sensitive. Placing commas

between command line options is optional. To modify the

startup.ncf file, follow these steps:

At the server console prompt type load nwconfig and press

Enter.

Select the NCF File Options menu and press Enter. Select the

Modify Startup.ncf option and press Enter.

Make the necessary changes. When you are done, press Esc.

Note:

You can also use your DOS text editor to modify the

startup.ncf file, it resides on the DOS partition.

UNIX

Installing the drivers for any of the UNIX systems is designed to be

done only from the driver disk, the creation of which is detailed at

the beginning of this chapter.

SCO OpenServer 5

Installing the Driver on a New System

In this scenario, you are installing the controller and driver in a

new OpenServer 5.x system.

To install the controller and driver:

Install and configure your Adaptec controller and hard disk

drives according to the instructions in Chapter 2. Create the

RAID that will host the operating system using the BIOS-based

utility that is built into the controller. See Creating a RAID 5

Without an Operating System on page 2-9 for details.

Create the driver disk as shown at the beginning of this chapter.

When finished, remove the driver disk.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 66 67

Brak uwag

Adaptec 2200S - SCSI RAID Controller Przewodnik Instalacji Strona 48