Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Podręcznik Użytkownika Pobierz pdf (Strona 195)

100

101

4-22 A-63054 February 2004

Batch tab The Batch tab allows you to define the batching function that is available in the

i800 Series Scanners.

Click on the Enable check box to enable scanner batching. When enabled the

scanner counts, a specified number of either Level 1, Level 2, or Level 3

pages. In Capture Software, Level 1 pages are referred to as Pages, Level 2

pages are referred to as Documents, and Level 3 pages are referred to as

Batches. When the specified number has been reached, the scanner will

perform an End of batch function. Then the counting starts all over again after

the scanner performs a Start of batch function.

NOTES: Scanner batching does not actually start until the scanner is

enabled within Capture Software and the scanner feeder and

transport are started.

Because scanner batching is based on page levels, it really only

makes sense when image addressing is also defined in scanner.

Batch type—specify the type of batching that is to be performed. Select one of

the following from the drop-down list:

Pages or Level 1 pages scanned.

Documents or Level 2 pages scanned.

Batches or Level 3 pages scanned.

Batch size—specify the number of the Batch type that will be counted by

the scanner to determine the end of a batch. A number from 1 to 32,000 is

allowed. When the scanner is enabled, the Batch size number is displayed on

the scanner operator control panel to indicate to the user that batching has

been enabled.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 411 412

Komentarze do niniejszej Instrukcji

Brak uwag

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Podręcznik Użytkownika Strona 195

Komentarze do niniejszej Instrukcji