Adaptec 2010S - SCSI RAID Storage Controller Podręcznik Użytkownika Pobierz pdf (Strona 103)

4-4

Adaptec Storage Management Software User’s Guide

followed by a drive address as discussed in Device Address Syntax

on page 4-2.

Multiple drive addresses on a command line must always be

separated by commas.

This switch can also be used to introduce a list of comma-separated

drive addresses in any command that uses such addresses. When

creating multilevel RAID10 or 50 arrays, separate drive groups

with a plus sign (+). The number of drives supported are listed

below:

Logical Drive Creation and Deletion

-c, -d Specify controller ID

This switch specifies the RAID controller to which all subsequent

parameters will apply. It is required for all operations. You can

specify a device which is attached to the controller, from which the

controller number will be derived, or you can enter the relative

controller number directly.

■ Use –c to specify the controller using the ID assigned to the

controller by your operating system.

■ Use –d to specify the controller ID in BIOS format. Adaptec

controllers are numbered starting from 0 according to their PCI

slot location. The boot controller or the controller in the lowest

number PCI slot is ID d0.

RAID 0 2 to 64 drives

RAID 1 2 to 64 drives (as pairs)

RAID 5 3 to 64 drives

Combined RAID SW-UG.book Page 4 Monday, September 9, 2002 1:25 PM

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 127 128

Brak uwag

Adaptec 2010S - SCSI RAID Storage Controller Podręcznik Użytkownika Strona 103