Adaptec 2110S - SCSI RAID Controller Przewodnik Instalacji Pobierz pdf (Strona 52)

3-17

Installing the Driver

22 If you system contains multiple Adaptec RAID controllers,

repeat Steps 14 through 21 for each controller. The system

should ask you to restart when this action is completed.

23 The Device Manager should now show an Adaptec I

O RAID

Host Adapter in the SCSI and RAID Controllers section.

24 Optional: Using a text editor, remove the following entries from

your

config.sys file:

device=i2oddl.sys

device=dptcdrom.sys

25 Optional: Using a text editor, remove the mscdex entry from

your

autoexec.bat file. When you complete the installation

procedure, these

config.sys and autoexec.bat file entries may no

longer be needed.

Adding the Controller to an Existing Windows 95/98/Me

System

In this scenario, you are adding an Adaptec RAID controller to an

existing Windows 95/98/Me system. To install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

2 Start up the system. During startup, press Ctrl+A to start

SMOR. Use SMOR to create the RAID. For details, refer to

Using SMOR on page 2-11.

3 Restart the system.

4 If Windows prompts for a driver to support a PCI card, go to

Step 11.

5 If Windows did not discover the devices during startup, open

the Device Manager. Look for a PCI card entry in the Other

Devices category. There may be multiple entries if you have

multiple Adaptec RAID controllers installed. There may also

be an entry for a PCI memory controller.

COMBINED RAID IG.BOOK Page 17 Tuesday, September 25, 2001 5:46 PM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 105 106

Brak uwag

Adaptec 2110S - SCSI RAID Controller Przewodnik Instalacji Strona 52