Adaptec 2110S - SCSI RAID Controller Przewodnik Instalacji Pobierz pdf (Strona 103)

D-3

Controller Reset Procedures

2 Insert the Adaptec RAID Installation CD into your drive and

restart your system.

3 Follow instructions and respond to prompts as necessary to get

to the Adaptec splash screen.

4 When you see the Adaptec splash screen, click Create Driver

Disk. Then, click the appropriate menu option.

5 Insert a floppy disk and click OK. The system creates the

bootable SMOR disk.

6 Remove the Adaptec RAID Installation CD and the driver floppy

disk.

7 Shut down the system.

8 If necessary, reinstall the controller in your system.

Now, to reset the controller firmware, BIOS, and SMOR, perform the

following tasks:

1 Install a jumper on flash mode 0 jumper connector. For the

location of the jumper connector, refer to Appendix A.

2 Insert the SMOR start disk and start the system. SMOR starts.

3 Use SMOR to flash the controller firmware.

4 Shut down the system.

5 Remove the jumper you installed in Step 1.

6 Restart the system from the SMOR start disk. If the system

restarts normally, the controller can now be configured using

SMOR or Storage Manager.

7 Use SMOR to flash the controller BIOS and SMOR images.

If the system fails to restart, call Adaptec Technical Support.

COMBINED RAID IG.BOOK Page 3 Tuesday, September 25, 2001 5:46 PM

1 2 ... 98 99 100 101 102 103 104 105 106

Brak uwag

Adaptec 2110S - SCSI RAID Controller Przewodnik Instalacji Strona 103