Adaptec ASH-1233 Podręcznik Użytkownika Pobierz pdf (Strona 14)

Connecting Your ATA Disk Drives

Connecting One ATA Disk Drive on a Cable

When you connect only one ATA disk drive to a cable, that disk

drive must be set as a master drive. (See Setting Jumpers on ATA Disk

Drives on page 5 for more information.)

To connect one ATA drive to the ASH-1233 adapter:

1 Connect the IDE cable to an IDE connector on the ASH-1233

adapter, being careful to match pin 1 of the cable to pin 1 of the

connector.

The cables and connectors are keyed. If the cable does not slide

easily into the connector, do not force it. Instead, reverse the

cable.

Note: The stripe along the edge of the cable indicates

Pin #1. If the cable does not slide easily into the connector,

reverse the cable.

2 Connect the other end of the IDE cable to a master drive, as

shown below on the left.

Repeat Step 1 and 2 to connect a second ATA disk drive to the

second IDE connector on the ASH-1233 adapter, as shown above

on the right. Both disk drives must be set as master drives.

Continue with Mounting ATA Disk Drives and Connecting Power

Cables on page 8.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Brak uwag

Adaptec ASH-1233 Podręcznik Użytkownika Strona 14