
1
AHA-1510A Install Guide
Part Number: 510399-00, Rev. A
Print Spec Number: 491841-00, Rev. A
Current Date: 4/7/93 ECN Date: 4/13/93
Hardware Installation
Adaptec AHA
™
-1510A AT
®
-to-SCSI host adapters
are designed to operate as shipped in most AT-
class computers. The default settings are:
SCSI Disconnection✱ Enabled
SCSI Address✱ 7
SCSI Parity✱ Enabled
Terminators Installed
Terminator Power Supplied by host adapter
Synchronous Negotiation✱ Disabled
Interrupt Channel 11
AT Port Address✱ 340h
Data Transfer Mode✱ Programmed I/O
✱
These values are set by the
aspi2dos
software
driver, provided with Adaptec EZ-SCSI or the
ASW-1210, and by command line options in the
config.sys
file (see Software Installation).
Installing the Host Adapter
1 Remove the cover of your computer to expose
the AT expansion slots.
2 Locate an unused AT expansion slot. AT-type
slots have two edge connectors (one 62-pin and
the other 34-pin) in line with each other.
3 Remove the expansion slot cover for this slot.
4 Align and insert the host adapter into the AT
slot. Use the expansion slot cover screw to
secure the host adapter to the frame.
5 Attach the SCSI cable(s) to the host adapter
and the peripherals, using the internal and/or
external connector(s). Be sure to maintain pin-1
orientation throughout the SCSI bus.
6 If the host adapter is not the first or the last
device attached to the cable (i.e., if both inter-
nal and external connectors are used), remove
the SCSI terminators from the host adapter.
7 Replace the cover and connect the power.
Caution
Turn OFF and disconnect power to the system and ex-
ternal equipment. Always refer to your system’s
documentation for instructions on removing the sys-
tem cover and adding option boards.
Komentarze do niniejszej Instrukcji