Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Przewodnik Instalacji Strona 54
- Strona / 86
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Installing SCSI software for the SIERRA™ plus film digitizer 52
VIDAR Film Digitizer Installation Guide
Computers with Windows 2000
Note:
Windows 2000 Service Pack 1 must be installed.
Computers without Service Pack 1 will not be supported.
1. When the computer boots up, it will detect the SCSI Adapter.
Quickly hit <Ctrl A> to access the SCSI Utility.
2. Follow the instructions in “Using the SCSI Utility,” later in this
chapter, to edit the BIOS settings. Return here after rebooting.
3. Windows 2000 will launch the New Hardware Wizard, which will
recommend the embedded AIC78xx.sys PCI SCSI driver. Accept this
driver, then complete the Wizard’s process.
Note:
If the New Hardware Wizard appears during the next
boot, cancel it.
Note:
Windows Millennium Edition does not contain an
embedded driver for the AHA-2930CU SCSI adapter. Adaptec
recommends loading the Windows 98 driver. Instructions for
loading PCI SCSI drivers under Windows ME can be found at
www.adaptec.com.
4. Install Adaptec EZ-SCSI software from the CD included in the SCSI
adapter kit. Reboot as prompted when installation is complete.
Note:
The EZ-SCSI CD wrapper may be marked “Adaptec EZ-
SCSI is not yet certified with Microsoft Windows 2000. It is not
recommended to install EZ-SCSI software in Windows 2000
environments.” Ignore that warning.
The ASPI driver installed
by EZ-SCSI is required for VIDAR film digitizer operation.
EZ-SCSI has been installed on many Windows 2000 computers
without problems.
5. After Windows 2000 has loaded, launch SCSI Explorer (
Start >
Programs > Adaptec EZ-SCSI 5.0 > SCSI Explorer
). Ensure that
the digitizer reports correctly in SCSI Explorer — the digitizer’s SCSI
ID is set to 3 at the factory, and it should report as such in this utility.
- Documentation questionnaire 1
- Comments are from 2
- Installation guide for 3
- Contents 5
- Unpacking 7
- 3. Identify the parts 12
- 4. Remove the shutter lock 15
- 5. If anything is missing 16
- Configuring SCSI settings 17
- SCSI ID switch 18
- Bottom of digitizer 18
- Table-top stand 22
- CAUTION: 24
- Pinch point 24
- Tighten by hand only 24
- 2. Mount the digitizer 25
- SAFETY WARNING 27
- 4. Connect the power cable 28
- 5. Connect the SCSI cable 29
- 6. Install the exit tray 30
- 7. Install the feed tray 31
- Multi-film feed tray cable 32
- To dig iti zer 33
- Power supply 33
- Power cord 33
- Wall mounting 34
- 1. Select proper wall space 35
- WARNING 39
- 4. Mount the digitizer 40
- 5. Connect the power cable 42
- 6. Connect the SCSI cable 43
- 7. Install the exit tray 44
- 8. Install the feed tray 45
- Installing SCSI hardware 48
- 2. Install the SCSI card 50
- Installing SCSI software 52
- Computers with Windows 2000 54
- Computers with Windows 98 56
- Computers with Windows 95 57
- Using the SCSI Utility 59
- Operating 62
- About films 64
- Loading a single film 65
- Loading multiple films 67
- Troubleshooting 69
- In case of difficulty 70
- Operational problems 71
- Appendix 76
- Warranty information 77
- End user information 79
- End user technical contact 79
- System configuration 80
- CD-ROM drive 81
- CD-R/W drive 81
- Diskette drive 81
- Serial ports 82
- USB ports and hub 82
- Parallel ports 82
- Video adapter 83
- Display 83
- SCSI adapters 83
- SCSI devices 84
- Digitizer 84
- Software 85
- Operating system 85
- Scanning software 85
- Scanning parameters 85
Powiązane produkty i podręczniki dla Nie Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps
Nie Adaptec AVA-1505A Podręcznik Użytkownika
(33 strony)
(33 strony)
Nie Adaptec APA-1480 Instrukcja Użytkownika
(24 strony)
(24 strony)
Nie Adaptec 1394 Podręcznik Użytkownika
(80 strony)
(80 strony)
Nie Adaptec AHA-2930CU Przewodnik Instalacji
(68 strony)
(68 strony)
Nie Adaptec ASA-7211C/F Podręcznik Użytkownika
(12 strony)
(12 strony)
Nie Adaptec 3940UW Podręcznik Użytkownika
(82 strony)
(82 strony)
Nie Adaptec 1742A Instrukcja Użytkownika
(9 strony)
(9 strony)
Nie Adaptec SBC-596 Instrukcja Użytkownika
(91 strony)
(91 strony)
Nie Adaptec ASH-1233 Instrukcja Użytkownika
(17 strony)
(17 strony)
Nie Adaptec APA-460 Przewodnik Instalacji
(58 strony)
(58 strony)
Nie Adaptec 39160 Przewodnik Instalacji
(38 strony)
(38 strony)
Nie Adaptec APA-358 Przewodnik Instalacji
(12 strony)
(12 strony)
Nie Adaptec AFW-1430 Podręcznik Użytkownika
(22 strony)
(22 strony)
Nie Adaptec 1742A Instrukcja Użytkownika
(68 strony)
(68 strony)
Nie Adaptec ACB-2010A Instrukcja Użytkownika
(9 strony)
Nie Adaptec 2940UW Podręcznik Użytkownika
(50 strony)
(50 strony)
Nie Adaptec 9110G Dokumentacja
(38 strony)
(38 strony)
Nie Adaptec AHA-1520A Przewodnik Instalacji
(8 strony)
(8 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji