Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Informacje Techniczne Pobierz pdf (Strona 82)

68 MetaFrame Solutions Guide

Installing Hummingbird Client Software

This section describes the client-side installation of the Hummingbird Application

Software. This must be done by each MetaFrame user who will run the

Hummingbird eXceed application.

1. Log on to the MetaFrame server as a user.

2. At a command prompt, type change user /install and press ENTER.

3. Run Setup from the \Exceed\Userins directory created in Step 7 above.

4. The first Setup popup asks you to specify the eXceed home directory. Specify

the directory created in Step 9 above.

5. The next popup asks you to specify the user’s home directory. Specify the

user’s home directory; for example, %SystemRoot%\Profiles\HermS\Exceed.

6. For users without rights to \%SystemRoot%\System32, three errors will appear

during the file copy, each saying “MoveFileEx: Error#{5}. The requested

access was denied.” Click OK each time. This indicates the administrator

copied the files to the proper directory in Steps 5, 6, and 7 above.

7. Each user must select a password to configure the X configuration setup.

8. You are asked if you want to tune the video display. Click Yes if Msvcrt20.dll

was copied into the %SystemRoot%\System32 directory. If it was not, click

No.

9. At a command prompt, type change user /execute and press ENTER.

Client Configuration

This section describes the client-side configuration of the Hummingbird

Application Software. This configuration must be done by each MetaFrame user

who will run eXceed.

1. After the eXceed client software is installed, double-click the Xconfig icon in

the eXceed program group.

2. Double-click the Communication icon. Set the mode to XDMCP-indirect and

select a unique display number for each user.

Each user must have a unique display number. If two users have the

same user number, incorrect program operation can occur.

3. Select Configure and enter the IP address of the X server running XDM.

4. Click OK twice.

5. Select the Windows Mode icon and set the Windows mode to Single.

6. Click OK.

7. Select the Transports icon, enter the broadcast address, and click OK.

Note

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 185 186

Brak uwag

Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Informacje Techniczne Strona 82