Adaptec 131CA - AAA RAID Controller Instrukcja Użytkownika Strona 4

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 4
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 3
R
Adaptec, Inc.
691 South Milpitas Boulevard
Milpitas, California 95035
Tel: (408) 945-8600
Fax: (408) 262-2533
Adaptec EuropeBelgium
Tel: (32) 2-352-34-11
Fax: (32) 2-352-34-00
Adaptec JapanTokyo
Tel: (81) 3-5276-9882
Fax: (81) 3-5276-9884
Adaptec Singapore
Tel: (65) 278-7300
Fax: (65) 273-0163
Literature:
1-800-934-2766 (USA and Canada)
or (510) 732-3829
Pre-Sales Support:
1-800-442-7274 (USA and Canada)
or (408) 957-7274
World Wide Web: http://www.adaptec.com
Internet ftp server: ftp.adaptec.com
CompuServe: GO ADAPTEC
Adaptec USA Bulletin Board (BBS):
(408) 945-7727 (up to 28,800 bps,
using 8 bits, 1 stop bit, no parity)
Interactive Fax: (408) 957-7150
Copyright 1997 Adaptec, Inc. All rights reserved. Adaptec, the
Adaptec logo, the Adaptec tagline, AAA, PhaseEngine,
ArrayConfig, Array1000, and Adaptec CI/O are trademarks of
Adaptec, Inc., which may be registered in some jurisdictions.
Microsoft, Windows, and Windows 95 are registered trade-
marks and Windows NT and the Windows NT logo are trade-
marks of Microsoft Corporation used under license. All other
trademarks used are owned by their respective owners.
Information supplied by Adaptec, Inc. is believed to be
accurate and reliable at the time of printing, but Adaptec, Inc.
assumes no responsibility for any errors that may appear
in this document. Adaptec, Inc. reserves the right, without
notice, to make changes in product design or specifications.
Information is subject to change without notice.
P/N 980261-011 4/97 Printed in U.S.A.
TECHNICAL SPECIFICATIONS
Computer Bus: 32-bit PCI Local Bus
Interface Protocol: Bus master DMA
Host Burst Data Transfer Rate: Up to 133 MByte/sec burst rate
SCSI Synchronous Data Rate: AAA-131
Up to 40 MByte/sec
(Burst rates) AAA-132 (OEM only)
Up to 80 MByte/sec
(40 MByte/sec per channel)
AAA-133
Up to 120 MByte/sec
(40 MByte/sec per channel)
Device Protocol: SCSI Ultra, Fast, and Wide (8- and 16-bit) 20 MHz
Advanced SCSI Features: SCSI PhaseEngine
®
coprocessor
Auto-termination
255 simultaneous commands
Scatter/gather
Tagged command queuing
Disconnect/reconnect
UltraSCSI 20 MHz for data transfer up to
40 MByte/sec per channel
Wide SCSI connection for up to 15 devices per channel
Advanced Hardware Features: Both 50- and 68-pin internal connectors
68-pin external connector (internal-to-external converter
available)
Flash BIOS
Electrical Drivers: Single-ended and active
PCI Bus: 32-bit, 33 MHz
SCSI Channels: 1, 2, or 3 fully independent PCI UltraSCSI channels bridged
to system PCI bus
Device Support: Up to 15 devices per channel
Array Support: Drives can be supported in array or non-array configurations
Up to 4 arrays configurable per AAA-13x
Up to 16 drives per array
RAID levels: 0, 1 (mirroring), 0/1, or 5
Operating System Support: Windows NT
3.51, 4.0, NetWare 3.12, 4.1, 4.11,
IBM OS/2 Warp**, SCO OpenServer**, UnixWare**
Remote Management: Windows
®
3.x, Windows
®
95, Windows NT 3.51, 4.0
RECOMMENDED MINIMUM SYSTEM REQUIREMENTS
PCI-based 90-MHz Pentium or equivalent motherboard with PCI-to-PCI bridge support
32 MByte system memory (NetWare)
48 MByte system memory (Windows NT)
PHYSICAL AND ENVIRONMENTAL SPECIFICATIONS
Dimensions:
AAA-131 6.93 inches (17.602 cm) by 4.2 inches (10.668 cm)
AAA-132 (OEM only) 12.28 inches (31.191 cm) by 4.2 inches (10.668 cm)
AAA-133 12.28 inches (31.191 cm) by 4.2 inches (10.668 cm)
Operating Temperature: 5˚C to 55˚C
Storage Temperature: 60˚C to 150˚C
Humidity (operating): 20% to 90%, non condensing
Power Requirements: 5V ± 5%
**Available in subsequent releases. Free upgrade.
COMPLETE KIT
AAA-131 or AAA-133 PCI-to-Wide
UltraSCSI array adapter
• Adaptec Array1000
Family Manager Set
software for Windows NT, OS/2,**
NetWare, SCO OpenServer,** UnixWare**
Adaptec CI/O Array Management
software
• Adaptec ArrayConfig initial boot array
installation software
One 50-pin and one 68-pin internal
ribbon cable with active termination
(external kit available)
• Complete documentation
®
Przeglądanie stron 3
1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag