Adaptec 29320-R SCSI Card Przewodnik Instalacji

Przeglądaj online lub pobierz Przewodnik Instalacji dla Karty interfejsu / adaptery Adaptec 29320-R SCSI Card. Adaptec 29320-R SCSI Card Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 1 - INSTALLATION GUIDE

INSTALLATION GUIDEADAPTEC SCSI CARD 29320ASC-29320 IG.fm Page 14 Wednesday, August 14, 2002 2:00 PM

Strona 2 - INTRODUCTION

9Connect the other end of the cable to a SCSI connector on the back of an external device. If you are installing only one external device, terminate t

Strona 3

10The last SCSI device on the end of each SCSI bus cable must be terminated, and termination must be disabled for all other devices in the middle of t

Strona 4 - SETTING UP SCSI DEVICES

11Preloaded Adaptec DriversIf the Adaptec SCSI Card 29320 was included as part of a computer system you purchased, the system already has the appropri

Strona 5 - CONNECTING SCSI DEVICES

12Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

Strona 6 - Nonterminated end

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interf

Strona 7 - Connecting Wide SCSI Devices

1The Adaptec SCSI Card 29320 enables you to connect up to 15 Low Voltage Differential (LVD) and/or 15 Single-Ended (SE) SCSI devices—such as very larg

Strona 8 - SCSI device

2Discharge any static electricity build-up before handling your SCSI card by touching a grounded metal object (like the exposed metal parts on the bac

Strona 9

3Computers may have vertical or horizontal expansion slots. Refer to your computer manual to locate the PCI/PCI-X slots. If your computer is a tower m

Strona 10 - Terminated SCSI device

4Check the SCSI IDsThe Adaptec SCSI Card 29320 and each device you connect to it must have a unique SCSI ID number ranging from 0 to 15 on each channe

Strona 11 - TROUBLESHOOTING

5cables are laminated so that they lay flat. Internal LVD cables usually have a terminator built into the end of the cable.The Adaptec SCSI Card 29320

Strona 12 - Embedded Adaptec Drivers

6Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable.

Strona 13 - Disclaimer

7Plug one end of the cable to the Wide SCSI connector on the Adaptec SCSI Card 29320. Plug the other end of the cable to a terminated Ultra/Fast Wide

Strona 14 - ■ EN55024 (1998) Immunity:

8Plug the other end of the cable to a terminated Ultra/Fast Narrow SCSI device.If you have other Ultra/Fast Narrow SCSI devices, attach them to the co

Komentarze do niniejszej Instrukcji

Brak uwag