Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Przewodnik Instalacji Strona 1

1IntroductionThis installation guide provides step-by-step instructions on install-ing your AHA®-2910C host adapter. This process involves installing

10Common Problems and Solutions Changed Values Not Loaded—If you changed any values on the host adapter in a Setup program or on a SCSI device, select

11Federal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this unit not expressly approved by the

RInstallationGuideAHA-2910CPCI-to-Fast SCSI Host AdapterAdaptec, Inc.691 South Milpitas Blvd.Milpitas, CA 95035© 1997, Adaptec, Inc. All rights reserv

2InstallationInstalling the Host AdapterStep 1: Turn OFF your computer and attached devices, and then disconnect the power cords.Step 2: Touch the met

3Step 6: OPTIONAL. If you want the LED in your computer to light whenever there is activity on the SCSI bus, disconnect the LED cable from the LED con

4Step 3: Align the SCSI cable’s colored stripe with Pin-1 on the SCSI device connector, and then plug it in. Step 4: Attach the remaining devices usin

5Step 4: Reconnect the power cables to the computer and external SCSI device. Step 5: Turn ON the external device and computer. Step 6: Go to Installi

6 NetWare, OS/2, and UNIX: Drivers for these operat-ing systems are not embedded, so you must load them yourself. If your host adapter came bundled wi

7If you connected a new SCSI hard disk drive to your host adapter, you must partition and logically format the drive. For DOS and Windows (3.x and 95)

8Default SettingsThe AHA-2910C has default settings appropriate for most PCI systems (see the table of settings below). Do not run SCSISelect unless y

9Using the SCSI Disk UtilitiesTo access the SCSI disk utilities, select the SCSI Disk Utilities option from the menu that appears after start-ing SCSI