Adaptec 131U2 - AAA RAID Controller Instrukcja Obsługi Pobierz pdf (Strona 12)

1-2

AAA-130U2 Series Installation and Hardware Guide

Use the Adaptec CI/O Management Software

™

, which is included

with the AAA-131U2/133U2, to create additional arrays (CI/O is

required for array management in order to provide the proper level

of fault tolerance and event notification). Refer to the Adaptec CI/O

Management Software User’s Guide for instructions on installing and

using the software.

System Requirements

The minimum system requirements for the AAA-131U2/133U2 are

■ PCI-based 90-MHz Pentium or equivalent motherboard with

PCI-to-PCI bridge support

■ An available half-length (for AAA-131U2) or full-length

(for AAA-133U2), unobstructed PCI slot that supports Bus

Mastering

■ A minimum of one SCSI hard disk

■ A standard 168-pin EDO 3.3v, 60ns or faster DIMM installed on

the adapter. (A DIMM is typically pre-installed.) See the

Adaptec Web Site at

http://www.adaptec.com/raid

for a list of

approved DIMMs and vendors

■ Five MBytes of free hard disk space for the AAA-131U2/133U2

software (five MBytes of free hard disk space on the Windows

system disk are also required for the temporary files created

during installation of the software)

■ Windows NT

™

4.0 Server, Windows NT 4.0 Workstation,

Novell NetWare 4.11, 4.2, or 5.0, or UnixWare 7.0.

■ A 3.5-inch 1.44-MByte primary (boot) floppy disk drive

■ 64 MBytes or more of system memory.

Caution:

An Uninterruptable Power Supply (UPS) is a key

feature for system fault tolerance. It is possible to lose data

due to power failure or power brown outs. In order to pre-

vent errors or data loss due to power failure, Adaptec

strongly recommends that a UPS be installed to support

your system.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Brak uwag

Adaptec 131U2 - AAA RAID Controller Instrukcja Obsługi Strona 12