Adaptec RS Series Podręcznik Użytkownika Pobierz pdf (Strona 21)

2-5

Unpacking and Initial Setup

Securely attach one end of the cable to the barrel of the 2-hole ground lug.

Using the two M5x8 metal screws, attach the 2-hole ground lug and 6 AWG

ground wire to the disk shelf. Do not overtighten the screws.

Connect the opposite end of the 6-AWG grounding wire to the appropriate

grounding point at your site, ensuring an adequate chassis ground.

WARNING: Prior to the interconencting of a shelf to any other equipment

or cabling, the shelf must be properly grounded. Should the connection to

ground require removal for any purpose, ensure that all other interconnect-

ing cables are removed first and such cables are not replaced until after the

ground is re-connected.

Device Insertion

This section details how to install power supply units, disk drives, and Advanced

Cooling Modules (ACM’s). The installation of a RAIDStation7 rackmount Stor-

age Array is shown below. For the tower version of the RAIDStation7 Storage

Array, Figure 2-3 would be oriented vertically, with bay 0 on top and bay 8 on the

bottom.

Figure 2-3. Location of devices in tower or shelf

WARNING: Before attempting to install or remove any of the components,

ensure that anti-static precautions have been taken. The minimum require-

ment is an anti-static wrist strap and grounding wire.

Power Supply

Disk Drive

Bay 0

Bay 8

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 50 51

Brak uwag

Adaptec RS Series Podręcznik Użytkownika Strona 21