Adaptec APA-1350 Przewodnik Instalacji Pobierz pdf (Strona 24)

ASI Hardware Installation Guide

In the back of your computer, locate the slot where you just installed the SCSI card. You should

see the card you installed sticking out the back.

Take one end of the SCSI cable (that comes with your ASI package) and plug it into the card

you installed. Tighten the screws so that the cable is firmly connected to the card.

Below is a picture of the back of the DVD player. Plug the end of the SCSI cable into the TOP

port of the DVD player. (The other end of the cable is connected to the card you installed in

your computer.) Included in the DVD package is a small gray connector, called a “terminator”.

Put the terminator on the BOTTOM port of the DVD player.

Plug the power cable into back of the DVD player, and turn the DVD player on.

Plug the power cable back into your computer, and turn your computer on. (If you had to

disconnect any other cables to install the SCSI card, you should reattach those cables at this

time.)

When you turn your computer on, your computer will detect the card and install the appropriate

drivers automatically.

Proceed to the next section of this manual, “Confirming Proper DVD Installation (MAC

Users)".

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Brak uwag

Adaptec APA-1350 Przewodnik Instalacji Strona 24