Adaptec 39320D Przewodnik Instalacji

INSTALLATION GUIDEADAPTEC SCSI CARD 39320DASC-39320D IG.fm Page 14 Thursday, June 13, 2002 10:53 AM

9Connect power cables to all external device(s) and to the computer.The last SCSI device on the end of each SCSI bus cable must be terminated, and ter

10Preloaded Adaptec DriversIf the Adaptec SCSI Card 39320D was included as part of a computer system you purchased, the system already has the appropr

11Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

12This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inte

© 2002 Adaptec, Inc. All rights reservedPart Number: 513221-06, Ver. AA JG 06/02RASC-39320D IG.fm Page 13 Thursday, June 13, 2002 10:53 AM

1The Adaptec SCSI Card 39320D enables you to connect up to 30 SCSI devices—such as very large arrays of high-performance hard disk drives, external st

2Support for Older SCSI DevicesIf you have single-ended Ultra SCSI and earlier SCSI devices, Adaptec recommends that you connect them together on one

3After you turn off your computer and unplug the power cord, remove the cover from the computer.Locate an unused 64-bit PCI expansion slot and remove

4Insert the Adaptec SCSI Card 39320D in the 64-bit (or 32-bit) PCI or PCI-X expansion slot; press down firmly until the card clicks into place, then r

5The Adaptec SCSI Card 39320D is preset to ID 7 for each channel and should not be changed. If you boot from a SCSI hard disk, make sure the hard disk

6The Adaptec SCSI Card 39320D has two separate Ultra320/160 SCSI channels, as shown in the figure on page 1. Channel A has an internal LVD/SE connecto

7Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable.

8Follow these steps to connect your external SCSI devices:Connect one end of an external SCSI cable to one of the external Ultra320/160 connectors on